how to open the specific scope

Asked by Venkatapathi on 9 Aug 2012
Latest activity Commented on by K E on 10 Aug 2012

Hi all i have a simulink model which consists of 20 to 30 scopes at diffrent subsystems. i would like to open the specific scopes ( may be 3 to 4 scopes at a time) automatically, once simulation time is completed.

my question is

1. is it possible to open the specific scopes automatically?

thanks to you for spending your valuable time.

Thanks & Regards venkat

1 Comment

K E on 10 Aug 2012

Just a head's up, a lot of scopes will slow your simulation; see this blog post.

Venkatapathi

Tags

Products

1 Answer

Answer by Azzi Abdelmalek on 9 Aug 2012
Edited by Azzi Abdelmalek on 9 Aug 2012
Accepted answer

assume

 ModelName='fic';     % your simulink model name
 SubsystemName='sub1'  
 ScopeName='scope1'
 % to open this scoppe :
 open_system('fic/sub1/scope1')
 % you can do the same to open any system or subsystemem
 % to close it
 close_system(ModelName)

3 Comments

Venkatapathi on 9 Aug 2012

Hi Mr.Azzi Abdelmalek

your solution is working...

Thank you very much

venkat

TAB on 9 Aug 2012

To open the scopes automatically when simulation is completed, add above code in model's StopFcn callback.

Venkatapathi on 9 Aug 2012

Hi TAB..

iam able to open the scopes automatically by using StopFcn callback..thanks

Azzi Abdelmalek

Contact us